Get Your Quote for Chandelier Fixture Mounting
Fill the form below to inquire about Electrical Services Ontario's Chandelier Fixture Mounting in Ajax.
Call Electrical Services Ontario at (289) 672-2825 about Chandelier Fixture Mounting in Ajax and get it fixed to real structure.
Fill the form below to inquire about Electrical Services Ontario's Chandelier Fixture Mounting in Ajax.
From weak ceiling boxes to tricky wiring, here are the mounting issues our clients call us about most often.
Most standard ceiling boxes are only rated for light fixtures under 50 pounds, not a heavier chandelier. Mounting a heavy fixture on the wrong box risks it pulling loose from the ceiling over time. We install a properly rated brace box anchored to a joist before mounting anything heavy.
An uneven hang usually means the mounting bracket wasn't seated flush or the canopy wasn't leveled during installation. Left as-is, the fixture can shift further out of alignment and stress the wiring connection. We level and secure every mount before signing off on the job.
Homeowners often want a chandelier centered over a new table or island rather than the original fixture location. Wiring a new box in the correct spot is required before mounting can begin, and skipping this step means a permanently off-center fixture. We run new wiring to the exact location you want.
Flickering right after a new chandelier goes up usually points to a loose wire nut connection or a mismatched dimmer switch. Left unresolved, a loose connection can arc and create a fire risk over time. We test every connection under load before leaving the site.
Vaulted or high ceilings make both the structural support and the physical mounting more complex, since standard ladders and boxes are not enough. Attempting this without the right equipment risks a serious fall or a fixture that eventually comes loose. We use proper scaffolding and reinforced mounting hardware for tall ceilings.
Homes with older wiring sometimes have brittle or undersized wire behind the existing fixture that isn't obvious until the old chandelier comes down. Mounting a new fixture onto compromised wiring is a genuine safety hazard. We inspect the wiring before installation and replace any section that doesn't meet code.
A wobbling fixture usually means the mounting screws weren't torqued to the bracket properly or the canopy isn't seated tight against the ceiling. Over time this movement can loosen the wiring connection inside the box. We secure every mounting point to hold the fixture completely still.
A chandelier that won't turn on, stays on constantly, or responds to the wrong switch usually means a wiring mismatch during the swap. This is more common when the old fixture used a different wiring configuration than the new one requires. We confirm switch function matches the new fixture before finishing the job.
A former ceiling fan box is sometimes rated to hold a chandelier, but not always, depending on how it was originally installed. Assuming it's safe without checking risks the same weight problem as an unrated fixture box. We verify the box rating before reusing it for a new chandelier.
Our dining room chandelier is heavier than it looks and the technician from Electrical Services Ontario insisted on checking the joist before mounting it. Glad he did, since the old box wasn't rated for the weight. Everything feels rock solid now.
Straightforward job, the old fixture came down and the new chandelier went up within an hour. No mess left behind and the wiring was clean when I checked it myself afterward.
We wanted the chandelier centered over our new table instead of the old fixture location. That meant running a new electrical box, which pushed the visit past the original estimate. Worth it for the right placement though.
I had no idea a regular fixture box couldn't hold my new crystal chandelier. Electrical Services Ontario walked me through why a brace box mattered before quoting the job, and I appreciated not being upsold on anything unnecessary.
Our entryway ceiling is close to fourteen feet and I was nervous about how they'd reach it safely. The Electrical Services Ontario crew set up properly and had the chandelier mounted and level without a single wobble.
The technician tested every connection before leaving and showed me the finished wiring inside the canopy. Small thing but it told me the job was done properly instead of just rushed through.

Tell us what is happening — no power, a breaker that will not reset, or a planned upgrade. We talk it through and book a time that works for you, including same-day for urgent calls.
A licensed electrician looks at the actual panel, circuit, and load rather than quoting over the phone, then gives you a firm written price with the scope set out line by line.
The electrician who quoted the job does the work. Drop sheets go down, permits are filed where the work calls for it, and you get an update before anything changes from the plan.
Every circuit is tested before we close the panel, the inspection is booked and the certificate handed over, and our labour is warrantied for two years.
Reach out to Electrical Services Ontario for panel upgrades, rewiring, EV chargers, generators, or emergency electrical repairs across Ajax.
Call, or send a message through the form below, either way an electrician gets back to you rather than a call centre.
CALL US (289) 672-2825 EMAIL US Click to send a messageYour message stays between us.